In my system I use several different methods of "powering up" amplifiers connected to squeeze devices, all of these work on the "Power" state of the players.
The problem I'm having is that I now have a valve (tube) power amplifier for my bedroom system this takes nearly a minute to warm up after power on this gives me two problems:-
The volume has ramped up quite a bit in the time the amp has taken to warm up and is loud and very distorted (due to the valves not being warm enough).
I have the same problem (to a far less extent) with my solid state amps which take a couple of seconds to un mute after power on
Is it possible to modify the alarm plugin to have a setting to switch player "power" on x seconds before the alarm is triggered ?
A time of 0 (or 1) to maybe 300 or 600 seconds to allow for some stabilization of amp parameters (whether SS or valve)
So there is no confusion when I say "Power" I mean the equivalent of clicking the power button![Name: 2018-03-04 12_37_19-Squeezelite-X.jpg
Views: 44
Size: 2.8 KB]()
in the Web GUI
Thanks
The problem I'm having is that I now have a valve (tube) power amplifier for my bedroom system this takes nearly a minute to warm up after power on this gives me two problems:-
The volume has ramped up quite a bit in the time the amp has taken to warm up and is loud and very distorted (due to the valves not being warm enough).
I have the same problem (to a far less extent) with my solid state amps which take a couple of seconds to un mute after power on
Is it possible to modify the alarm plugin to have a setting to switch player "power" on x seconds before the alarm is triggered ?
A time of 0 (or 1) to maybe 300 or 600 seconds to allow for some stabilization of amp parameters (whether SS or valve)
So there is no confusion when I say "Power" I mean the equivalent of clicking the power button
Thanks