Hi
I've built a system using picoreplayer 3.22 and a 320x240 TFT touch screen.
Following instructions at http://www.pughx2.com/picore320.html I've got the whole thing very close to working.
Everything is fine except Jivelite, which presents a bit of a splash screen for a few seconds, then quits - and goes round this forever due to the loop in jivelite.sh.
What I don't understand is why jivelite doesn't start.
I see the LCD screen working - I can see the boot sequence on it
I've tested the touch screen suing ts_calibrate.
If the screen and touch screen are working, why would jivelite fail to start ?
Can some kind soul explain reasons why Jivelite would quit after putting up the splash screen ?
Thanks
I've built a system using picoreplayer 3.22 and a 320x240 TFT touch screen.
Following instructions at http://www.pughx2.com/picore320.html I've got the whole thing very close to working.
Everything is fine except Jivelite, which presents a bit of a splash screen for a few seconds, then quits - and goes round this forever due to the loop in jivelite.sh.
What I don't understand is why jivelite doesn't start.
I see the LCD screen working - I can see the boot sequence on it
I've tested the touch screen suing ts_calibrate.
If the screen and touch screen are working, why would jivelite fail to start ?
Can some kind soul explain reasons why Jivelite would quit after putting up the splash screen ?
Thanks